Honda Accord Wheel Bolt Pattern and Offset Guide
What is the bolt pattern for a 2007 Honda Accord?
The 2007 Honda Accord uses a 5-lug wheel bolt pattern with a pitch circle diameter of 114.3 mm. This is commonly written as 5x114.3. The same bolt pattern is shared across many Honda and Acura models from this era, which makes wheel interchange relatively straightforward when the other wheel measurements also match.
Bolt pattern by Accord generation
The Accord's bolt pattern changed over time. The 5x114.3 pattern applies to several generations, but earlier four-cylinder and V6 models did not always share the same lug count. The following examples cover commonly referenced model years.
Model year range | Typical bolt pattern | Notes; 1994-1997 | 4x114.3 or 5x114.3 | Four-cylinder models often used 4-lug; V6 and some trims used 5-lug; 1998-2002 | 4x114.3 or 5x114.3 | Four-cylinder commonly 4-lug; V6 commonly 5-lug; 2003-2007 | 5x114.3 | Applies to most four-cylinder and V6 trims; 2008-2012 | 5x114.3 | Eighth generation continued the 5-lug pattern
Wheel offset and fitment
Wheel offset is the distance from the wheel's mounting surface to the centerline of the wheel barrel. A positive offset means the mounting surface sits closer to the outer face, pushing the wheel inward. A negative offset moves the wheel outward.
For a 2007 Honda Accord, a typical factory wheel offset is approximately +55 mm. Replacement wheels with a slightly lower positive offset, often in the +40 mm to +50 mm range, are commonly used when the wheel width increases. Using an offset far outside the original specification can change steering feel, increase stress on suspension components, and cause tire contact with the fender or suspension.
Center bore and other fitment details
The 2007 Accord hub center bore is approximately 64.1 mm. Wheels with a larger center bore can be fitted with hub-centric rings to reduce vibration. A wheel with a smaller center bore will not seat correctly on the hub. Always confirm the center bore when using wheels from a different vehicle platform, even if the bolt pattern matches.
What to check before changing wheels
Bolt pattern must match the hub: 5x114.3 on a 2007 Accord; earlier 4-cylinder models may have been 4x114.3 instead; Offset should stay close to factory specification unless a specific fitment has been verified; Center bore must be equal to or larger than the hub size, with hub-centric rings as needed; Lug nuts must match the seat type of the new wheel; many Honda wheels use a ball or spherical seat rather than a conical seat
Practical guidance
If you are replacing wheels on a 2007 Accord, start by confirming that the new wheel is 5x114.3 and has a center bore of at least 64.1 mm. Check the offset against the factory value and avoid aggressive changes unless the wheel and tire package has been test-fitted. For earlier Accords, verify whether the car has four or five lug nuts before ordering wheels, since both 4x114.3 and 5x114.3 appear within the same model generations.