Dodge Hellcat Wheel Bolt Pattern: Sizes, Fitment and What to Check
Direct Answer
The Dodge Challenger SRT Hellcat, Charger SRT Hellcat and related widebody variants use a 5x115 millimeter bolt pattern. This means the wheel has five lug holes arranged on a circle with a diameter of 115 millimeters. The measurement applies to standard-body and widebody Hellcat models sold in North America. Always confirm the specific model year and trim because wheel width and offset change even when the bolt pattern stays the same.
Model Scope and Fitment
The 5x115 bolt pattern is consistent across the Challenger SRT Hellcat, Challenger SRT Hellcat Redeye, Charger SRT Hellcat and Charger SRT Hellcat Redeye. Standard-body cars and widebody cars share the same lug spacing, but they require different wheel widths and offsets. A wheel that clears a standard fender may sit too far inward or rub on a widebody car.
Hub Bore, Thread Pitch and Torque
The center bore on Hellcat models is commonly documented as 71.5 millimeters. The lug studs use a 14x1.5 millimeter thread pitch. A typical dry torque specification for the lug nuts is 111 pound-feet, though the exact figure can vary slightly by source and should be verified against the owner's manual or a factory service document. Use a calibrated torque wrench and tighten in a star pattern.
Wheel and Tire Considerations
Bolt pattern is only one part of fitment. A 5x115 wheel may still cause interference if the offset, width or brake clearance is wrong. Hellcat models use large Brembo brake calipers, and not every 5x115 wheel has enough spoke or barrel clearance. Narrowbody and widebody widths differ, so a replacement wheel should match the documented offset range for the specific body style.
Qualification and Verification
The 5x115 bolt pattern is for Dodge Charger and Challenger Hellcat models sold in the North American market. Imported or specialty-market vehicles could theoretically differ, and aftermarket hub conversions can change fitment. Before buying wheels, spacers or adapters, check the actual vehicle by measuring the bolt circle or confirming the original equipment specification for that model year and trim.
Next Action
If you are selecting new wheels, filter by 5x115 bolt pattern first, then narrow by width, offset and brake clearance for your body style. If you are rotating or reinstalling factory wheels, confirm the lug nut thread engagement and torque them to the recommended specification in the correct sequence.