Honda CR-V Wheel Bolt Pattern
Direct Answer and Scope
The 2012 Honda CR-V uses a 5x114.3 mm wheel bolt pattern. This value applies to all standard trim levels of that model year sold in North America, including the LX, EX, and EX-L. The measurement is sometimes written as 5x4.5 inches, which is the imperial equivalent. This bolt pattern is shared across several Honda and Acura vehicles, but wheel fitment depends on more than the bolt pattern alone.
Required Wheel Dimensions
For a wheel to physically mount to a 2012 CR-V, it must match the bolt pattern and also meet the hub and stud requirements. The center bore of the wheel is 64.1 mm. Wheels designed for a smaller center bore will not seat correctly. Factory lug nuts use a ball seat rather than a conical seat, so replacement wheels should be paired with the correct type of lug nut if the seat shape changes.
The factory wheel width for the 2012 CR-V is 6.5 inches for steel wheels and 7 inches for alloy wheels. The stock wheel diameter is 16 or 17 inches depending on trim. Factory offset for these wheels is approximately +50 mm. When considering aftermarket wheels, staying within a few millimeters of this offset helps preserve steering feel, bearing life, and clearance for the brake components.
Compatible Tire Sizes
The 2012 CR-V was originally equipped with either 215/70R16 or 225/65R17 tires. A change in wheel diameter or width may require a corresponding tire size to keep the overall diameter consistent. Substantial differences from the factory overall diameter can affect the accuracy of the speedometer and odometer. When moving to a wider wheel, verify that the tire section width remains appropriate for the wheel width and that loaded suspension travel does not cause rubbing against the fender liner or suspension arms.
Fitment Notes for Replacement Wheels
Wheels from other vehicles with a 5x114.3 bolt pattern may still require verification of center bore and offset. A wheel with the correct bolt pattern but a smaller center bore cannot be installed without machining the bore to match the CR-V hub. A wheel with a much lower offset will push the tire outward and may contact the body under compression. Before purchasing a used or aftermarket set, confirm all three measurements: bolt pattern, center bore, and offset.
Summary
For a 2012 Honda CR-V, select wheels with a 5x114.3 mm bolt pattern, a 64.1 mm center bore, and an offset near +50 mm. Use the lug nut seat shape that matches the wheel, and keep tire diameter close to factory specifications unless a deliberate change is being made. Checking these details before ordering reduces the chance of fitment problems during installation.